Portfolio

960E Engine Bay Guardrails (In Progress) Problem Maintainers raised concerns because the risks of falling increase when they are required to remove the deck ab [...]

L1850 Engine Fall Protection System (In Progress) Before: Unprotected open edges & areas when panels are removed After: Set of guardrails for both sides of the engi [...]

793 Engine Bay Protection System (In Progress) Before After After: Working Platform (Under construction) Problem A maintainer fell down from the engine bay of [...]

MT4400 Hoist Cylinder Platform (In progress) After After: Hoist Cylinder pin Problem The limited space around the lift cylinders and the lack of a proper platf [...]

793 Access Platform Before: Location of steps doesn't provide a safe access to the work area After: New access platform with incorporated guardrails (Right side) Afte [...]

MT4400AC Rectifier Handrail Before After: The rectifiers to be inspected are behind this cover  Problem The routine inspection of the rectifiers on the Terex [...]

L1850 Articulation Access Panels Before: Gap between platform and articulation After: LH Infill Panel Problem Previously, we were using one of the existing p [...]

L1850 Access Platform Before After: New platforms are 1200mm wide and have a large landing area Problem When conducting maintenance activities on the Letourne [...]

L1850 Bucket Tilt Cylinder Platform Cylinders After: 1.5m Walkway provides enough space to work around the cylinders Problem The bucket tilt cylinder change o [...]

960E Engine Bay Hand Rails Before: Fall and trip hazards After: Self-closing Door After: Bolt to secure hand rail and engine bay door Problem An incident occur [...]

960E Access Platform After: Maintainers have easy access to air filters After: Maintainers also have easy access to top areas of trucks without the need of EWP Pro [...]

960E Engine Platform Before: Ladder is too narrow to carry tools. After: Swivel wheels with locks After: Removable hand rails to fit into different work areas P [...]

960E Wheel Motor Platform Before After: Width of working area is now 650mm Problem When we needed to remove or replace wheel motors we had limited access with [...]